CRL/Somaca Medium Viscosity Auto Glass Urethane Adhesive

Home > Exterior > Auto Glass > Adhesives , Sealants, Cleaners > Adhesives >

Retail Price: $8.99
You Pay!: $6.49
You save $2.50!

Availability:: Usually Ships in 24 to 72 Hours
Part #: 1217449

Qty:

Description

CRL/Somaca Medium-Viscosity Urethane Adhesive is a fast curing adhesive that passes or exceeds U.S. Federal Motor Vehicle Safety Standards FMVSS212 (Barrier Crash Test) and FMVSS208 (Occupant Crash Protection) in its most severe interpretation with dual air bags and unrestrained dummies. The fast curing formula is tack free in only 50 ±10 minutes and offers Safe Drive Away Time in as little as 3 hours when used on vehicles without a passenger side air bag, 6 hours with passenger air bag at 73°F (23°C) and 45% RH (relative humidity).

Cleaning and Primers
CRL/Somaca Urethanes are supported by a one-step primer and aerosol cleaner formulated for use in all aspects of glass bonding, including the glass frit, pinchweld, and EPDM/PVC moldings.
1. After removing all of the old urethane to within 1/16 inch (1.5 millimeter) of the pinchweld, prepare the pinchweld following the procedures outlined in the CRL Technicians Training Manual. Prime these areas with 1214006 One Step Primer.
2. Clean the inside of the windshield with a lint-free towel 1550 and PWR22 Automotive Glass Cleaner.
3. Apply the same 1214006 One Step Primer to the frit area with a lint-free towel and allow to dry for a minimum of 10 minutes, but no more than 8 hours before installing the adhesive. This procedure must be performed above 40°F (4°C). NOTE: One Step Primer must be used prior to any adhesive application to prevent glass displacement. Failure to do so may result in personal injury or property damage.
4. Apply 1214006 One Step Primer to encapsulated moldings if they are part of the bonding area.

Important Notes: For use by trained applicators only. Please refer to C.R. Laurence Technician Training Manual, Technical Spec Data Sheet and Material Safety Data Sheet before using product. 1214006 One Step Primer must be used prior to any adhesive application to prevent glass displacement. Failure to do so may result in personal injury or property damage. Store cartridges closed and upright when not in use. Store between 65°F (18°C) and 75°F (24°C) in dry conditions.

Meets or Exceeds U.S. Federal Motor Vehicle Safety Standards 208 and 212
Value Priced, Fast Curing, Cold Applied
Part of the LYNX Services Program

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Exterior > Auto Glass > Adhesives , Sealants, Cleaners > Adhesives
Exterior > Auto Glass > Adhesives , Sealants, Cleaners